
New TopShim run:

version = topshim 2.4.0
date = 2026-11-12
time = 18:00:09.774
command = topshim  convcomp ordmax=4

FINE SHIMMING

Parameters:

probe = Z104275_0310
solvent = CDCl3
shim nucleus = 2H
nucleus optimised for = 1H
o1p (from lock) = 7.24 ppm

Results:


1D Shimming:
Low S/N encountered. The acquisition parameters will be changed to improve this issue.
echo time must be reduced
echo time must be reduced

NOTE: very poor map quality encountered despite the CONVCOMP option being used.


NOTE: very poor map quality encountered despite the CONVCOMP option being used.

Iteration  1: FWHM Before=42.6 Hz, Target= 4.5 Hz, After=23.2 Hz

NOTE: very poor map quality encountered despite the CONVCOMP option being used.

Iteration  2: FWHM Before=23.2 Hz, Target= 0.4 Hz, After=13.7 Hz

NOTE: very poor map quality encountered despite the CONVCOMP option being used.

Iteration  3: FWHM Before=13.7 Hz, Target= 3.1 Hz, After= 5.0 Hz

NOTE: very poor map quality encountered despite the CONVCOMP option being used.

Iteration  4: FWHM Before= 5.0 Hz, Target= 3.0 Hz, After= 3.9 Hz

NOTE: very poor map quality encountered despite the CONVCOMP option being used.

Iteration  5: FWHM Before= 3.9 Hz, Target= 2.0 Hz, After= 3.0 Hz
Diverging behaviour detected. Shimming was aborted.
Using the best result as the final shim state.

Lineshape quality factor (1D spectrum, spinning) = 14.2

shim changes: 
Z	+1380
Z2	+7347
Z3	+32279
Z4	-84452

duration = 10 min 45 sec
completed successfully
finished Thu Nov 12 18:10:53 2026


========================================================================
